On a (sweater) roll!

I finished my Luminos Tee. It looked great right off the needles, and even better after wet blocking. The size stayed the same, but the stitches and edges are smoother. I knew the size would be consistent, because I knit, washed, and blocked a swatch. That’s always good for a sweater that you want to fit!

A quick mirror selfie. Yarn is a kit from Knits All Done/Yarn Snob, merino/silk/cashmere. Luxurious!

Do I always knit, wash, and block swatches? Usually yes, for sweaters. But I’ve been eyeing the Ranunculus sweater, and I’m not sure it matters. The instructions are the same for all sizes through the yoke; the actual size is determined after knitting the yoke, when beginning the raglan shaping. You can use any weight yarn, and a size 10 needle is recommended. That’s all pretty loosey-goosey!

I wanted to play with some fingering weight linen that’s in my stash. Most of it is in an abandoned design project. There are 3 untouched skeins (50g/168 yards each), so I can play with what’s there without ripping the old project yet. This sweater takes 370 to 400 yards for the short sleeve version, so I’m covered!

It would make a very open and airy Ranunculus, to go over a tank top or sundress. I decided to jump in and start knitting; it’s just as easy as making a circular gauge swatch. I’ll have enough done when the yoke is finished to really figure out my gauge, and adjust accordingly. Because blocking is transformative for linen, I could put it on waste yarn and wash and block. Or not. The smallest size in this pattern gives me 10 inches of ease, so I’m not worried that it would be too small.